Nautilus Hats

Stitches used
Knit (K)
Purl (P)
Stockinette Stitch (STst)
Increase by knitting in front and back loop (Inc)
Make one with a yarn over (YO)
Knit 2 together (K2tog)
Seed St (SS)

His Version (worked flat)
Please excuse the picture, the hat is far too large for me but my model has been under the weather. This hat can be worked in the round, simply remove the 2 extra stitch for selvage and work on double pointed needles. Directions for adult size S (M/L) [Width 12.5″ (13.75/15″).] For best results, measure recipient’s favorite hat length, or measure from crown of head to top of eyebrows.

Row 1: K
Row 2: and all even rows: Purl
Row 3: K1 *K1, Inc 1* to last st, K1
Row 5: K1 *K2, Inc 1* to last st, K1
Row 7: K1 *K3, Inc 1* to last st, K1
Row 9: K1 *K4, Inc 1* to last st, K1
Repeat in this manner adding one more stitch before each Inc until you have a total of 100 (110, 120) stitches.
Work in STst to within 0.75″ of desired total length of hat. If you don’t know the desired length, work to about 8″ making sure that the last row is a WRONG SIDE row.
Work 3 rows of contrasting color, switch back to main color
Work one row
Purl one row (this will be the point where you fold the hat to make the hem.
Work 5 more rows in STst
DO NOT BIND OFF.
Folding hat along purl row, whip stitch or kitchner stitch the final row of stitches to the inside of the hat to form a hem.
With tapestry needle, sew up back seam from bottom to top. Run thread through the CO stitches and close up the small hole at the top.
Weave in any ends.

Her Hat (worked in the round)
Since the eyelets are worked the entire length of the hat, it’s best to work this hat in the round. I prefer my hats a little shorter than some, but the directions allow you to easily adapt the length. This hat can even be tried on as you go. While the eyelets are really easy, it’s entirely possible that a mistake could be made in the process. You’d be surprised how hard it can be to rip out and fix even the most simple lace patterns. Read about “life-lines” in the pattern for Hooray For Me Gloves. I suggest throwing a life-line in every 5-10 rows depending on your skill level.

Hat written for size S (M/L) [Width 11.25″ (12.5/13.75)]

CO 10 and distribute over 3 or 4 double pointed needles
Row 1: K
Row 2: and all even rows: K
Row 3: *K1, YO* around
Row 5: *K2, YO* around
Row 7: *K3, YO* around
Row 9: *K4, YO* around
Repeat in this manner adding one more stitch before each Inc until you have a total of 90 (100, 110) stitches.
If you would like, you can move the hat to small circumference circular needles at this point.
Row 1: *K2tog, K7(8, 9), YO* around
Row 2: K
Repeat rows 1 & 2 until hat is within an inch of desired total length. (If in doubt, work about 6.5 inches)
Work 1″ of SS

Weave in any ends, and if you’d like, close up the hole at the top of the hat.